Page 1 of 1
Hi from Saltdean!
Posted: Thu May 20, 2010 1:41 pm
by tonyscout
Hi,
I'm Tony from Saltdean, owner/builder of a Tiger Cat E1 - and building a 1986 JBA Falcon kit - much harder than the Cat was!!
I run the website for the Sussex Kit Car Club and am looking for some "E" marked perspex to make some side windows for the JBA!!
I intend to attend a few more runs (last one was Bentley!)
Tony T
Re: Hi from Saltdean!
Posted: Thu May 20, 2010 5:25 pm
by Ben_Copeland
Hi and Welcome... Good luck finding Emarked perspex

Re: Hi from Saltdean!
Posted: Thu May 20, 2010 6:06 pm
by Nash
Hi Tony and welcome. I suggest it's not Perspex you are looking for as it's brittle and will splinter. You want Macrolon or Plexiglass. Both of which are suitable and you should be able to get them e marked.
In terms of trying to find them I suggest Google is your friend.
From a club perspective if you know of any runs or points of Interest PM me and I'll get them on the map.
Once again welcome.
.......... Neil
Re: Hi from Saltdean!
Posted: Thu May 20, 2010 8:03 pm
by greenwoo
Blimey Tony T, that has to be the longest wait we've had so far for an introduction - from registering to posting

hope all is good with you?? i trust that you've waxed lyrical to your fellow Sussex colleagues about the site.......
catch up with you soon....
Re: Hi from Saltdean!
Posted: Thu May 20, 2010 8:26 pm
by Nogoingback
Look forward to a run down to Saltdean for tea and cake.
Re: Hi from Saltdean!
Posted: Sat May 22, 2010 9:15 am
by Nash
Bryan, sorry to Hi jack this thread but what is your Avatar picture of? Looks like fabric off a baby seat?!
........Neil