VARIOUS REAR WHEEL DRIVE FORD BITS AND MERCEDES BITS

[ncj]

Having a bit of a clear out, Ive got a exhaust manifold for a Zetec [made by Power Speed] also an alloy bellhousing , fits between Zetec and Ford type 9 gearbox 100 pounds each. Also got some old Mercedes bits. fuel distributer for 190E 2.6 etc and 2 alloy wheels and roof rack and headlight for same car, good used condition. offers?

[bobg_24]

Hi 'mcj',

Any photos of the manifold?

What was it fitted in previously?

Bob

[Nash]

Bob, assume it eas fitted to a Zetec.

If the question is what car then assume a Fury IMHO

.......... Neil

[Fury1630]

If the manifold's come from a Fury then I could be interested - 'bout time I started collecting parts. Any photos?

T

[bobg_24]

Neil,



You knew exactly what I meant.

Bob

[ncj]

Yes,both from a Fury, the one down at Power Speed. No photos of either but can assure you the manifold was made by power Speed and is very well made .The Bell housing is a Raceline one. Why not come on the Power Speed run on 13th March.?

[Fury1630]

...... but can assure you the manifold was made by power Speed and is very well made.

I wasn't doubting it, I was more interested if it ran over or through the chassis.

Looking into wether I can make the powerspeed run.

T

[ncj]

I think the answer is over the chassis and then down towards the cill. Bit difficult to remember exactly havnt seen the car for a month or so.
hope you can make the run

[Luke Neville]

Hi there ncj,

Is the bellhousing the aluminium one? Also, if you are able to post this, how much would the P&P be?


Thanks


Luke

[Nash]

Luke, there are lots of us wizzing about most weekends someone will most likely be going close to you at some point and could arrange a collection / drop off.

........... Neil