SKCC - Southern Kit Car Club. A Club for kit car owners across Southern England. Kent, Sussex, East Hants, Surrey, Berks, Middlesex, London

Posted: **Fri Jun 23, 2017 9:49 pm**

I've fitted a new U/J to my propshaft all went together ok but it seems quite stiff, it's been a while since I fitted one so I'm not sure if it's normal...

Posted: **Fri Jun 23, 2017 10:32 pm**

stiff is better than floppy , ooooh, errrr,

Posted: **Sat Jun 24, 2017 5:56 am**

Sounds like a mallet job. When we replaced them we always gave the flange a belt across the joint in all 4 directions of the uj or if the front it would be the yoke we hit.

Posted: **Sat Jun 24, 2017 3:01 pm**

Some hefty whacks with the copper headed mallet seems to have fixed it. Should be ok for tomorrow so long as I can get up in the morning!

Posted: **Sat Jun 24, 2017 5:45 pm**

Yay!

Just let me know your address and my Zetec can do the rest.

Posted: **Sat Jun 24, 2017 8:21 pm**

SKCC - Southern Kit Car Club. A Club for kit car owners across Southern England. Kent, Sussex, East Hants, Surrey, Berks, Middlesex, London

Propshaft U/J Problem

Propshaft U/J Problem

Re: Propshaft U/J Problem

Re: Propshaft U/J Problem

Re: Propshaft U/J Problem

Re: Propshaft U/J Problem

Re: Propshaft U/J Problem