Help engine mount

[locost220]

As expected, can you fabricate or not ( nothing to be ashamed of if not) , just give me a better idea of the time required,
Rich

[Kegco]

Hi Dick, my mount look quite thin as in thickness of the tube and the tube has torn around the cylinder, just below the weld. engine side of the mount. Do you know would the mounts come with the build kit or would it of been fabricated by the builder.

[Dick]

The mounts would have come as part of the build kit they are thin , you could drop down and see what we done to mine if you want but give us a call first to make sure one of us is around. bring a camera

[Kegco]

Hi Rich,
Never really tried with metal or had to as first kit, I'm in no real rush but it would be nice to get out on a few more runs this year, but the way this car is going it's one thing after another
Cheers

[Kegco]

Cheers Dick ,
Much appreciated,
Will do

[Fury1630]

I have a pair of mounts in the garage doing nothing, they are Fury X-Flow mounts, but the burton kit is X-Flow / Pinto, so they should line up at the engine end, cut & re-weld at the chassis end if required.

Yours for the price of the postage.

[Kegco]

Cheers, if they are going spare and you don't need them, that will be great.
I'll PM my address. Let us know how much I owe you and how you want paying.
Thanks again
Kev

[Fury1630]

They should be in the post by tomorrow - PM sent

01.jpg (252.24 KiB) Viewed 2928 times

02.jpg (227.12 KiB) Viewed 2928 times

[Fury1630]

Hi Kev, the engine mounts are now with Mark Greenwood, who lives near you apparently.

[greenwoo]

Kev, drop me an email or a PM and can arrange to drop it off if i'm out and about or you're welcome to pick up from Otford area during the week....